LD Half Arrow – R/H Corner Edge

ADVANTAGES
• Compatible with all Sandvik and non-Sandvik loader buckets.
• No structural modifications required to install system.
• Faster GET change-outs than replacing the entire lip.

BENEFITS
• Extend bucket service life.
• Maintain bucket capacity for longer.
• Reduce the frequency of lip rebuilds.
• Reduce the total cost of ownership of loader and bucket.

HALF ARROW – LIGHT DUTY
Suitable for small to medium-sized loaders operating in normal mining conditions.

Lip thickness range = 25mm – 38mm

Item number: 69040159 Category: Tag:

The Half Arrow Series is a range of weld-on lip protection systems designed to extend the life of loader buckets by preserving the structure of the primary lip. The range’s advanced design allows for good penetration of muck piles and optimization of material flows during dumping. GET in the Half Arow range are constructed from a Sandvik wear-resistant alloy that delivers a high performance-to-weight ratio.

CHARACTERISTICS
• Constructed from custom high-performance, wear-resistant Sandvik SS2000 steel alloy.
• Dedicated corner edges protect high-wearing zones.
• Self-sharpening profile to maintain mucking performance.
• Optimized for maximum GET wear and reduced waste material at end of life.
• Built-in weld prep areas for easy installation.

Loaders

Sandvik LH202, Sandvik LH203, Sandvik LH204, Sandvik LH307, Caterpillar R1300, Epiroc ST2D, Epiroc ST2G, Epiroc ST3.5, Epiroc ST7

Version

Light duty